خراب سي ڊيز مان 10 منٽ وارو ويري ايبل ڪئپسٽر ڪيئن ٺاهجي پنهنجا تجربا پاڻ ڪريو سامان جيڪي توهان کي گهربا Supplies you will need: 1.) Sharpie 2.) Superglue 3.) CD case (slim) 4.) 2 CD's 5.) Wire (26 AWG) 6.) Heavy Paper 7.) Glue Stick 8.) Tinfoil sheet 9.) Pocket or Exacto knife 10.) Plastic bottle cap
اچو ته پهرئين سي ڊي ڊسڪ ڪان پليٽون ٺاهيون۔ a.) Turn both CD's upside down and cover them half-way with glue from the glue stick b.) Place CD's glue side down on tinfoil so only the glue covered part of the CD is on the tinfoil c.) Wait for Glue to dry and then trim excess foil of with the knife d.) Cut desired length of wire off and remove insulator about 1/4 inch e.) pass wire thru center opening from non-tinfoil side to tinfoil side and tape exposed portion to foil e.) Set aside for now
اچو ته هاڻ انهن سي ڊيز مان ٺاهيل پليٽن لاِ هولڊر ٺاهيون a.) Place 1 CD in the jewel case and close lid b.) Center the Bottle cap on the lid open side up c.) Use the sharpie to trace the outline of the bottle cap d.) Remove the lid from the jewel case e.) VERY CAREFULLY use the back of the knife tip to scrap the plastic away under the sharpie line until the center piece falls out
Step 3: Finish second plate assembly a.) Use point of knife to open a small hole in the center of the top of the bottle lid b.) add a ring of superglue to the top of the lid and attach to the second CD on the non-tinfoil side c.) cut off piece of wire and strip the insulation off for 1/4 inch and pass thru hole in lide d.) Tape exposed portion of wire to tinfoil
Step 4: Assembly a.) install first plate tinfoil side up in the CD holder with wire hanging out one side b.) Use superglue to permanently attach the CD to the holder c.) trim Sheet of paper to completely cover the CD and be easily installed into holder d.) reattach the jewel case lid e.) pass bottlecap of plate 2 thru the opening in the jewel case and close the lid. f.) You should be able to easily spin the top CD now, but it should not spin on its own g.) tape the lid closed (loose enough for cd to still spin)
The Equation of a plate capacitor is: C=[0.2248*k*A]/d Where k is dielectric constant most plastics it's 2.4 A is the area of one plate in square inches and d is the distance between the 2 metal plates in inches Voltage breakdown is about 600volts per 0.001 of an inch up to 0.005 inch at which point the max voltage can't be exceeded by much unless you add more plates in series.
capacitance depends on the area of the plates and inversely to the thickness of the dielectric and also the dielectric constant of the dielectric. http://www.daycounter.com/Calculators/Plate-Capacitor-Calculator.phtml http://members.gcronline.com/cbrauda/0007.htm using wild guesses I get about 750 pF
